In this article, we will discuss the best way to clean shower head. It is normal that showerhead spray unevenly because of their tiny holes have gotten plugged with dirt deposits. To restore the good flow of water from the showerhead you need to remove these deposits. There are several ways to do that but you should follow the right technique depending upon your showerhead configuration. You may also want to soak the showerhead in vinegar and for then you need to remove the showerhead from the shower arm.
Best way to Clean Shower Head:
To properly clean the shower head you need to figure out whether your showerhead is newer or older. The newer showerhead fix onto the shower arm pipe that comes out of the shower wall. However, the older models feature a shower head arm with a ball-shaped end that works as a swivel for the shower head.
1.) Tool-Free Shower Head Cleaning
If you can’t remove your shower head or simply want to skip that step then you can soak the shower head by using a rubber band and a plastic bag. Remember, this method is best for shower heads made with stainless steel, chrome, or other protected metal surfaces.
You should first slip a rubber band over the top of the shower head. Now, you may want to loop it around the shower arm one or two times so that plastic bag will stay in place. Now, fill a plastic bag with white vinegar and attach the bag to the shower head by slipping the top of it under the rubber band. Wait 45 minutes and then remove the bag and start the water flow to flush. Finally, polish with a soft cloth to clean shower head.
2.) Disconnect the Shower Head
Be gentle while disconnecting the shower head. Carefully, unscrew the nut at the shower arm. Take care not to ruin the fixture’s finish. You should use a wrench rather than pliers to prevent any damage. Cushion the heavy tool with a rag while you work. Disconnecting the shower head need little bit professionalism. However, this method ensures the proper cleaning of the shower head for a good water flow. You need to disconnect the shower head if the mineral deposits prove to be beyond the range of vinegar. Why removing shower head from the arm will give you freedom to do a more thorough cleaning.
3.) Rinse the Shower Head
Once you have successfully disconnected the shower head then run a sharp blast of water through the shower head by firmly holding it upside down under a faucet. The objective of rinsing the shower head is to remove loosened debris out through the opening that joins to the shower arm.
4.) Dismantle and Clean the Shower Head
Dismantle and clean your showerhead if there are still mineral deposits left on it. You can scrub the shower head with an old toothbrush and vinegar to loosen dirt and debris. You can also use a toothpick or safety pin to poke out extra deposits. Then simply soak the parts in vinegar overnight as it will dissolve any remaining deposits then rinse again.
5.) Reassemble and Reinstall of Shower Head
Once you are satisfied with the cleaning of showerhead then you should first wrap new plumbing tape around the threads of the shower arm. This will ensure a good firm seal. Now, reattach the shower head to the shower arm using the wrench, not pliers. You need to protect the fixture’s finish with a soft rags or towels while you are working.
